Miu Miu Embellished leather sandals wEWwTgF

SKU-987228298
Miu Miu Embellished leather sandals wEWwTgF
Miu Miu Embellished leather sandals
United States

A website dedicated to strategy, film and discussion of Nebraska football

On Philipp Plein Sneaker EbZ13ET4E
By In - Offense

For the first Concept Wednesday of the Scott Frost era, we’re going to look at one of Frost’s favorite vertical passing concepts: Saints. Saints is yet another play in the Frost playbook that can be traced directly to Chip Kelly. It was Kelly’s preferred vertical concept in Philadelphia and San Francisco, and I expect it will feature heavily in UCLA’s offense as long as Kelly is in Los Angeles. Saints is also responsible for several of UCF’s explosive plays in 2016 and 2017, as Frost used his speed at the skill positions to kill defenses down the field with one-on-one matchups.

For now, let’s take a look at the core Saints concept and then a variation Frost ran in the Spring Game that led to Jaevon McQuitty’s first touchdown in a Husker uniform.

Saints is a three-vertical play action pass based off the Huskers’ zone run look:

The blocking up front looks like a standard zone run, and the Huskers can block inside or outside zone depending on what they’ve used most in the game. But this is pure play action, as the RB makes an initial run fake before running a flat route. If he gets pressure from that side, he’ll abandon the route and look to pick up any blitzer unaccounted for by the offensive line. If the defense is particularly adept at rushing the passer, you will also see the offensive line convert this into straight pass drops rather than giving a zone run look.

To the RB’s side, there are two primary receivers. This can be a combination of a TE and WR or a slot WR with another WR outside of him. The #1 WR (labeled “S” above) will run a skinny post that may convert depending on coverage. If he gets soft coverage and can’t get on top of the CB with the post, he can convert the route to a comeback after initially breaking to the post. The #2 WR to the same side (labeled “Y”) will also run a route that converts depending on the coverage. If he gets a single-high safety that closes the middle of the field, the #2 WR will run a deep crossing route. If he gets two-high safeties and the middle of the field is open, he will stay vertical and split the safeties’ coverage drops.

On the other side of the field, you’ll get a high-low combination from two WRs. The most typical route combination is the one seen above, a go route from the #1 WR (labeled “X”) and a bubble from #2 (labeled “Z”) underneath him. This is designed to vertically stretch the CB. If the CB sinks with X, the ball goes to Z. If the CB triggers down on Z, the ball is thrown to X in the hole before the FS can widen. You will also see Frost run this with a quick out from Z rather than a bubble, which is just another way to get into the high-low combination.

Download citation file:

© 2018 Oxford University Press

TOMS Cotton SlipOn Shoes Z5LPxOb
Close
Advanced Search

Abstract

Root growth in the field is often slowed by a combination of soil physical stresses, including mechanical impedance, water stress, and oxygen deficiency. The stresses operating may vary continually, depending on the location of the root in the soil profile, the prevailing soil water conditions, and the degree to which the soil has been compacted. The dynamics of root growth responses are considered in this paper, together with the cellular responses that underlie them. Certain root responses facilitate elongation in hard soil, for example, increased sloughing of border cells and exudation from the root cap decreases friction; and thickening of the root relieves stress in front of the root apex and decreases buckling. Whole root systems may also grow preferentially in loose versus dense soil, but this response depends on genotype and the spatial arrangement of loose and compact soil with respect to the main root axes. Decreased root elongation is often accompanied by a decrease in both cell flux and axial cell extension, and recent computer-based models are increasing our understanding of these processes. In the case of mechanical impedance, large changes in cell shape occur, giving rise to shorter fatter cells. There is still uncertainty about many aspects of this response, including the changes in cell walls that control axial versus radial extension, and the degree to which the epidermis, cortex, and stele control root elongation. Optical flow techniques enable tracking of root surfaces with time to yield estimates of two-dimensional velocity fields. It is demonstrated that these techniques can be applied successfully to time-lapse sequences of confocal microscope images of living roots, in order to determine velocity fields and strain rates of groups of cells. In combination with new molecular approaches this provides a promising way of investigating and modelling the mechanisms controlling growth perturbations in response to environmental stresses.

, , , , ,
Issue Section:

Plants require a root system that delivers adequate water and nutrients for shoot growth, and to anchor them in the soil. The optimum distribution of root length depends mainly on the distribution of water and nutrients in the soil. In dry seasons plants may require long main root axes to access water stored deep in the soil profile, whilst if abundant water and nutrients are available, only a small fraction of the root length may suffice. Roots of individual plants may experience a wide range of soil conditions, and as much variation has been recorded within 0.5 m of the stem base as across a 100 m 2 field plot ( Jackson and Caldwell, 1993 ). Soil matric potential may be drier than −1.5 MPa (permanent wilting point) at the soil surface on a summer day, but saturated at a depth of 1 or 2 m, if a water table is present. Soil physical stresses may limit root elongation; for example, if the soil is too wet with insufficient oxygen diffusion to the root tip resulting in hypoxia; insufficient water availability if the matric potential is too negative; and mechanical impedance if the soil is too hard due to compaction or soil drying ( Taylor and Ratliff, 1969 ; Blackwell and Wells, 1983 ; Sharp et al ., 1988 ; da Silva et al ., 1994 ). Soil physical stresses have sometimes been found to interact to decrease root elongation more than predicted from the combination of stresses acting independently. Interestingly, this effect has only been observed in maize roots ( Gill and Miller, 1956 ; Barley, 1962 ; Mirreh and Ketcheson, 1973 ; Goss et al ., 1989 ) and not, as yet, in other species ( Taylor and Gardner, 1963 ; Taylor and Ratliff, 1969 ; Greacen and Oh, 1972 ). It is a considerable challenge to evaluate the most important factors limiting the growth of the crop, and to understand the mechanisms underlying the root growth responses.

Skip navigation links
Java™PlatformStandardEd.8
compact1, compact2, compact3
java.util.jar

Class Attributes

The Attributes class maps Manifest attribute names to associated string values. Valid attribute names are case-insensitive, are restricted to the ASCII characters in the set [0-9a-zA-Z_-], and cannot exceed 70 characters in length. Attribute values can contain any characters and will be UTF8-encoded when written to the output stream. See the JAR File Specification for more information about valid attribute names and values.
The attribute name-value mappings.
Constructs a new, empty Attributes object with default size.
Constructs a new, empty Attributes object with the specified initial size.
Constructs a new Attributes object with the same attribute name-value mappings as in the specified Attributes.
Returns the value of the specified attribute name, or null if the attribute name was not found.
Returns the value of the specified attribute name, specified as a string, or null if the attribute was not found. The attribute name is case-insensitive.

This method is defined as:

Returns the value of the specified Attributes.Name, or null if the attribute was not found.

This method is defined as:

Associates the specified value with the specified attribute name (key) in this Map. If the Map previously contained a mapping for the attribute name, the old value is replaced.
Associates the specified value with the specified attribute name, specified as a String. The attributes name is case-insensitive. If the Map previously contained a mapping for the attribute name, the old value is replaced.

This method is defined as:

Removes the attribute with the specified name (key) from this Map. Returns the previous attribute value, or null if none.
Returns true if this Map maps one or more attribute names (keys) to the specified value.
Returns true if this Map contains the specified attribute name (key).
Copies all of the attribute name-value mappings from the specified Attributes to this Map. Duplicate mappings will be replaced.
Removes all attributes from this Map.
Returns the number of attributes in this Map.
Returns true if this Map contains no attributes.
Returns a Set view of the attribute names (keys) contained in this Map.
Returns a Collection view of the attribute values contained in this Map.
Returns a Collection view of the attribute name-value mappings contained in this Map.
Compares the specified Attributes object with this Map for equality. Returns true if the given object is also an instance of Attributes and the two Attributes objects represent the same mappings.
Returns the hash code value for this Map.
Returns a copy of the Attributes, implemented as follows: Since the attribute names and values are themselves immutable, the Attributes returned can be safely modified without affecting the original.
Skip navigation links
Java™PlatformStandardEd.8

New Look Wide Fit WIDE FIT KAKE Ballet pumps black EtH99UkYcn
For further API reference and developer documentation, see Nike Sportswear AIR MAX 90 ESSENTIAL Trainers blue void/game royal/white 4W3pYEmYPt
. That documentation contains more detailed, developer-targeted descriptions, with conceptual overviews, definitions of terms, workarounds, and working code examples. Copyright © 1993, 2018, Oracle and/or its affiliates. All rights reserved. Use is subject to license terms . Also see the documentation redistribution policy .

Student Services Center

Harris Hall 2831 Thurman DriveRaleigh, North Carolina 27695

Hours: Monday - Friday 8:00 a.m. - 5:00 p.m.

P: 919.515.NCSU (6278)

© 2018 NC State University. All rights reserved.